EASYGUARD EC002PP Remote Starter with PKE Passive keyless Entry, Push Start Button, Fit for Key Start Gas Engine Jeep Wrangler 10-18 only firmware preloaded

Dear Customer, Please read the following notice before purchasing: This item CANBUS remote starter with PKE only fit for gas engine Jeep Wrangler 2010-2018 year with standard key start only. Please make sure you have the right vehicle as list here when buying. Note: 1. when buying, please check above the product description page carefully to see if which is the right item you plan to buy. 2. No need to use bypass to process original car key. When dealing with the car chip immobilizer, please take out the battery from car OEM remote and put the car OEM keys into the induction coil. 3. You need to unlock/remove the steering wheel lock when do the installation. Main feature: 1. SEMI Plug & play, no damage to the original car circuit，CAN BUS compatible. 2. Plug & play with OBD2 connector & T-harness, no damage to the original car circuit 3. Although the device is plug & play, we recommend you install it by a trained alarm installer or professional alarm installer to install it if you have no alarm installation experience. Main feature: 1. Upgrade key start to Push button start/stop PKE-passive keyless entry Manual arm/lock & disarm/unlock Mute/audible alarm Remote trunk release Panic mode Valet mode on/off setting Remote engine start/stop Central door locking automation Programming method( pre-programmed before shipping, no need to re-program them again).

• This remote starter with PKE kit only fit for gas engine with standard key start Jeep Wrangler 2010-2018. Not fit for other vehicles not list here. please pay attention to this point while buying.
• SEMI Plug & play with OBD2 connector & T-harness, no damage to the original car circuit, CAN BUS compatible& firmware proloaded.
• Upgrade your key start vehicle to push start button with PKE-passive keyless entry, remote engine start & more feature.
• When dealing with the car chip immobilizer, please take out the battery from car OEM remote and put the car OEM keys into the induction coil, inset your factory key into the ignition lock, turn the key to ON position to unlock/release the steering wheel lock, then you can shift the gear ！！！
• No need to use bypass to process original car key.
• This device is semi plug & play, we recommend you install it by a trained alarm installer or professional alarm installer, if you have no alarm installation experience. especially if you don't know how to remove the cars trim/dashboard panels and don't know how to where the wire harness is connected.
• Can upgrade to smartphone app control & 4G LTE GPS tracking, need to buy an extra GPS002-AA 4G LTE module(ASIN:B0D95Y1XN3)